News Detail

Specificatioin:

Model: 2 inch manual hydraulic pipe bender

Name: Integral hydraulic pipe bending machine

Output: 16T

Range: 240mm

Crimping range: 1/2 "-2"

Outer diameter: Φ22mm-Φ60mm

Configuration mold: 1/2' 3/4' 1' 11/4' 11/2' 2'

Pipe wall thickness: 2.75-4.5mm

Weight: 44.5kg

Model: 3 inch manual hydraulic pipe bender

Name: Integral hydraulic pipe bending machine

Output: 18T

Range: 320mm

Crimping range: 1/2 "-3"

Outer diameter: Φ22mm-Φ89mm

Configuration mold: 1/2' 3/4' 1' 11/4' 11/2' 2' 21/2' 3'

Pipe wall thickness: 2.75-4.5mm

Weight: 91kg

Guidance:

1. Tighten the switch of the manual hydraulic pipe bender, and lubricate the contact part of the supporting wheel and mold with the workpiece to be bent.

2, According to the size of the bent pipe, select the corresponding bending die and installed on the top of the piston rod, the corresponding size slot of the two supporting wheels facing the bending die, pay special attention to the supporting wheel should be placed in the corresponding size hole on the side of the wing plate, "the largest size outside the hole." And so on. Avoid the asymmetry of the position of the two supporting wheels, and damage the mold and parts.

3. After placing the workpiece, cover the upper wing plate, first use the fast pump to press the bending mold to the workpiece, and then use the slow pump to press the workpiece to the required Angle. After bending, open and close, the working piston will automatically reset, open the upper wing plate, and take out the workpiece.